User Tools

Site Tools


zeiss_lsm_710

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
zeiss_lsm_710 [2020/01/15 11:02]
bioimaging [Microscope Turn On Procedure]
zeiss_lsm_710 [2020/01/15 12:22] (current)
bioimaging [Microscope Turn Off Procedure]
Line 91: Line 91:
 ===== Microscope Turn Off Procedure ===== ===== Microscope Turn Off Procedure =====
  
-If there'​s ​another user for this microscope in the next hour+If there is another user for this microscope in the __next hour__
-  * Close the software, leave the lasers on and log off the computer +  * Close **ZEN**, leave the lasers onlog off the computer 
-  * Clean up any objective where you used immersion ​oil. +  * Clean up immersion ​objectives
-  * **Make sure that there really is another user going to use the microscope.**+
 Else: Else:
   * Turn off the 561 nm laser and incubator in the software (if used)   * Turn off the 561 nm laser and incubator in the software (if used)
   * Switch the Ar laser from ''​run''​ to ''​idle''​ (if used)   * Switch the Ar laser from ''​run''​ to ''​idle''​ (if used)
   * Turn off the Ar laser using the key (if used)   * Turn off the Ar laser using the key (if used)
-  * Clean up any objective were you used immersion ​oil. +  * Clean up immersion ​objectives 
-  * Exit the softwareshut down the computer. +  * Close **ZEN**shutdown ​the computer. 
-  * Turn off the metal halide ​lamp +  * Turn off the metal halide ​fluorescence light source 
-  * Turn off the main switches ''​SYSTEMS/​PC''​ and ''​COMPONENTS''​+  * Turn off the two switches''​SYSTEMS/​PC''​ and ''​COMPONENTS''​
   * Wait 5 min. for Ar laser cooldown   * Wait 5 min. for Ar laser cooldown
-  * Turn off the ''​MAIN SWITCH''​.+  * Turn off the ''​MAIN SWITCH''​
  
 ---- ----
 [[resources|Back to the Resources page]] [[resources|Back to the Resources page]]
zeiss_lsm_710.txt · Last modified: 2020/01/15 12:22 by bioimaging