User Tools

Site Tools


zeiss_lsm_710

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
zeiss_lsm_710 [2020/01/15 11:02]
bioimaging [Microscope Turn On Procedure]
zeiss_lsm_710 [2020/01/15 12:22]
bioimaging [Microscope Turn Off Procedure]
Line 91: Line 91:
 ===== Microscope Turn Off Procedure ===== ===== Microscope Turn Off Procedure =====
  
-If there'​s ​another user for this microscope in the next hour+If there is another user for this microscope in the __next hour__
-  * Close the software, leave the lasers on and log off the computer +  * Close **ZEN**, leave the lasers onlog off the computer 
-  * Clean up any objective where you used immersion ​oil. +  * Clean up immersion ​objectives
-  * **Make sure that there really is another user going to use the microscope.**+
 Else: Else:
   * Turn off the 561 nm laser and incubator in the software (if used)   * Turn off the 561 nm laser and incubator in the software (if used)
   * Switch the Ar laser from ''​run''​ to ''​idle''​ (if used)   * Switch the Ar laser from ''​run''​ to ''​idle''​ (if used)
   * Turn off the Ar laser using the key (if used)   * Turn off the Ar laser using the key (if used)
-  * Clean up any objective were you used immersion ​oil. +  * Clean up immersion ​objectives 
-  * Exit the softwareshut down the computer. +  * Close **ZEN**shutdown ​the computer. 
-  * Turn off the metal halide ​lamp +  * Turn off the metal halide ​fluorescence light source 
-  * Turn off the main switches ''​SYSTEMS/​PC''​ and ''​COMPONENTS''​+  * Turn off the two switches''​SYSTEMS/​PC''​ and ''​COMPONENTS''​
   * Wait 5 min. for Ar laser cooldown   * Wait 5 min. for Ar laser cooldown
-  * Turn off the ''​MAIN SWITCH''​.+  * Turn off the ''​MAIN SWITCH''​
  
 ---- ----
 [[resources|Back to the Resources page]] [[resources|Back to the Resources page]]
zeiss_lsm_710.txt · Last modified: 2024/01/18 01:18 by bioimaging