Differences

This shows you the differences between two versions of the page.

--- zeiss_cell_observer [2020/01/14 18:33]
bioimaging [System Turn On Procedures]
+++ zeiss_cell_observer [2020/01/14 18:40]
bioimaging [Microscope Turn Off procedures]
@@ Line 96: / Line 96: @@
 ===== Microscope Turn Off procedures =====
-  * Exit the **ZEN 2** software
+If there is another user for this microscope is the __next hour__:
+  * Leave the fluorescent light source on
+  * Clean up immersion objectives
+Else:
+  * Exit the ZEN software
   * Turn off the computer (not the UPS!)
 {{:cell_observer_pc_vs_ups.png?250|}}
-  * If you used any __immersion oil in the objectives, clean them up__.
+  * Clean up immersion objectives
-  * Turn off the microscope power supply (B)
+  * Turn off the microscope power supply (**B** on remote control)
   * Turn off the Definite Focus controller (if used)
-  * Turn off the Motorized Stage controller (A)
+  * Turn off the motorized stage controller (**A** on remote control)
   * Turn off the Temperature and CO2 controller (if used)
-  * If there's __another user__ for this microscope in the __next hour__ leave the mercury __lamp power source on, else turn it off__.
+  * Turn off the HXP 120 fluorescent light source
-  * Be extra careful in weekends and at the end of the day to make sure that the mercury lamp is not going to be turned on for an excessive time.
 ----
 [[resources|Back to the Resources page]]

Bioimaging Wiki