zeiss_axiovert_200m
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
zeiss_axiovert_200m [2020/01/14 17:42] bioimaging [System Turn On Procedures] |
zeiss_axiovert_200m [2020/01/14 17:46] bioimaging [Microscope Turn Off procedures] |
||
|---|---|---|---|
| Line 105: | Line 105: | ||
| * If the software doesn't detect the camera, power cycle the camera and try again | * If the software doesn't detect the camera, power cycle the camera and try again | ||
| ===== Microscope Turn Off procedures ===== | ===== Microscope Turn Off procedures ===== | ||
| - | * Turn off the computer. | + | |
| - | * Turn off the camera. | + | If there is another user for this microscope in the __next hour__: |
| - | * If you used any __immersion oil in the objectives, clean them up__. | + | * Leave the fluorescent lamp on |
| - | * Turn off the microscope stage controller. | + | * Clean up immersion objectives |
| - | * Turn off the microscope. | + | Else: |
| - | * If there's __another user__ for this microscope in the __next hour__ leave the mercury __lamp power source on, else turn it off__. | + | * Clean up immersion objectives |
| - | * Be extra careful in weekends and at the end of the day to make sure that the mercury lamp is not going to be turned on for an excessive time. | + | * Shutdown the computer |
| + | * Turn off the camera | ||
| + | * Turn off the Prior stage controller | ||
| + | * Turn off the microscope | ||
| + | * Turn off the fluorescent lamp | ||
| ---- | ---- | ||
| [[resources|Back to the Resources page]] | [[resources|Back to the Resources page]] | ||
zeiss_axiovert_200m.txt · Last modified: 2024/02/12 22:50 by bioimaging
Page Tools
