prairie
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
prairie [2025/01/11 16:55] bioimaging |
prairie [2025/01/11 17:06] (current) bioimaging |
||
|---|---|---|---|
| Line 64: | Line 64: | ||
| | Ch2 (GaAsP) | Green | 570-620 nm | mCherry, Alexa568, Cy3 | | | Ch2 (GaAsP) | Green | 570-620 nm | mCherry, Alexa568, Cy3 | | ||
| | Ch3 (GaAsP) | Far Red | 500-550 nm | GFP, Alexa488, FITC | | | Ch3 (GaAsP) | Far Red | 500-550 nm | GFP, Alexa488, FITC | | ||
| - | | Ch4 (PMT) | Blue | 435-485 nm | DAPI, CFP or BS 2nd Harmonic | | + | | Ch4 (PMT)* | Blue | 435-485 nm | DAPI*, CFP or SHG | |
| + | |||
| + | *Ch4 can be used either in fluorescence mode, or alternatively as a BF ("DODT") channel or for SHG - ask staff | ||
| \\ | \\ | ||
| **Upon request:** | **Upon request:** | ||
| \\ (requires changing filters and the dichroic beamsplitter) | \\ (requires changing filters and the dichroic beamsplitter) | ||
| - | |||
| - | {{::alternative_filtersetDiagram.png |}} | ||
| - | \\ | ||
| - | ^ Detector ^ Filter ^ Transmission ^ Fluorochromes ^ | ||
| - | | Ch1 | - | - nm | Cy5 | | ||
| - | | Ch2 | - | - nm | Alexa568 | | ||
| - | | Ch3 | - | - nm | Alexa488 | | ||
| - | | Ch4 | - | - nm | DAPI | | ||
| - | | DODT | - | - nm | BF | | ||
| - | \\ | ||
| UNDER CONSTRUCTION!!! | UNDER CONSTRUCTION!!! | ||
| Line 91: | Line 84: | ||
| ===== System turn Off procedures ===== | ===== System turn Off procedures ===== | ||
| + | |||
| + | * Transfer your data to the institutional server (data is deleted every 3 months) | ||
| + | * Clean up immersion objective(s) | ||
| + | * Remove all your samples and accessories and leave the working area ready for the next user | ||
| If there is another user for this microscope in the __next hour__: | If there is another user for this microscope in the __next hour__: | ||
| - | * Leave the fluorescent lamp and lasers on | + | * Leave the fluorescent lamp and LASER "ON" |
| - | * Clean up immersion objectives | + | * Inform staff you are leaving the system "ON" |
| + | |||
| Else: | Else: | ||
| - | * Clean up objective(s) | + | * Set the LASER to "Standby" (LASER key to the left) |
| - | * Set the laser to ''standby'' | + | * Turn "OFF" all pre-amps (make sure to protect 1st for Ch1&2! |
| - | * ... | + | * Turn "OFF" the fluorescence lamp |
| + | * Turn "OFF" monitor, lights, and close the microscope curtains | ||
| + | * Make sure you turn "OFF" any life support unit used (heating, CO2, O2...) | ||
| ---- | ---- | ||
| [[resources|Back to the Equipment page]] | [[resources|Back to the Equipment page]] | ||
prairie.1736610957.txt.gz · Last modified: 2025/01/11 16:55 by bioimaging
Page Tools
