This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
zeiss_lsm_710 [2020/01/15 11:02] bioimaging [Microscope Turn On Procedure] |
zeiss_lsm_710 [2020/01/15 12:22] bioimaging [Microscope Turn Off Procedure] |
||
---|---|---|---|
Line 91: | Line 91: | ||
===== Microscope Turn Off Procedure ===== | ===== Microscope Turn Off Procedure ===== | ||
- | If there's another user for this microscope in the next hour: | + | If there is another user for this microscope in the __next hour__: |
- | * Close the software, leave the lasers on and log off the computer. | + | * Close **ZEN**, leave the lasers on, log off the computer |
- | * Clean up any objective where you used immersion oil. | + | * Clean up immersion objectives |
- | * **Make sure that there really is another user going to use the microscope.** | + | |
Else: | Else: | ||
* Turn off the 561 nm laser and incubator in the software (if used) | * Turn off the 561 nm laser and incubator in the software (if used) | ||
* Switch the Ar laser from ''run'' to ''idle'' (if used) | * Switch the Ar laser from ''run'' to ''idle'' (if used) | ||
* Turn off the Ar laser using the key (if used) | * Turn off the Ar laser using the key (if used) | ||
- | * Clean up any objective were you used immersion oil. | + | * Clean up immersion objectives |
- | * Exit the software, shut down the computer. | + | * Close **ZEN**, shutdown the computer. |
- | * Turn off the metal halide lamp | + | * Turn off the metal halide fluorescence light source |
- | * Turn off the main switches ''SYSTEMS/PC'' and ''COMPONENTS'' | + | * Turn off the two switches: ''SYSTEMS/PC'' and ''COMPONENTS'' |
* Wait 5 min. for Ar laser cooldown | * Wait 5 min. for Ar laser cooldown | ||
- | * Turn off the ''MAIN SWITCH''. | + | * Turn off the ''MAIN SWITCH'' |
---- | ---- | ||
[[resources|Back to the Resources page]] | [[resources|Back to the Resources page]] |