This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
zeiss_lsm_710 [2016/04/05 02:06] bioimaging [Microscope Turn On Procedure] |
zeiss_lsm_710 [2016/04/05 02:12] bioimaging [Microscope Turn Off Procedure] |
||
---|---|---|---|
Line 86: | Line 86: | ||
* Switch the Ar laser from ''idle'' ton ''run'' (don't change the ''current'') | * Switch the Ar laser from ''idle'' ton ''run'' (don't change the ''current'') | ||
{{laser_run_710.jpg?100}} | {{laser_run_710.jpg?100}} | ||
- | * Start the ''ZEN 2009'' software | + | * Start the **ZEN 2012** software |
===== Microscope Turn Off Procedure ===== | ===== Microscope Turn Off Procedure ===== | ||
+ | |||
If there's another user for this microscope in the next hour: | If there's another user for this microscope in the next hour: | ||
- | * Close the software, leave the lasers on an log off the computer. | + | * Close the software, leave the lasers on and log off the computer. |
- | * Clean up any objective were you used immersion oil. | + | * Clean up any objective where you used immersion oil. |
* **Make sure that there really is another user going to use the microscope.** | * **Make sure that there really is another user going to use the microscope.** | ||
Else: | Else: | ||
Line 103: | Line 104: | ||
* Wait 5 min. for Ar laser cooldown | * Wait 5 min. for Ar laser cooldown | ||
* Turn off the ''MAIN SWITCH''. | * Turn off the ''MAIN SWITCH''. | ||
+ | |||
---- | ---- | ||
- | [[groups:bioimage:resources|Back to the Resources page]] | + | [[resources|Back to the Resources page]] |