This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
zeiss_cell_observer [2020/01/14 18:33] bioimaging [System Turn On Procedures] |
zeiss_cell_observer [2020/01/14 18:40] bioimaging [Microscope Turn Off procedures] |
||
---|---|---|---|
Line 96: | Line 96: | ||
===== Microscope Turn Off procedures ===== | ===== Microscope Turn Off procedures ===== | ||
- | * Exit the **ZEN 2** software | + | If there is another user for this microscope is the __next hour__: |
+ | * Leave the fluorescent light source on | ||
+ | * Clean up immersion objectives | ||
+ | Else: | ||
+ | * Exit the ZEN software | ||
* Turn off the computer (not the UPS!) | * Turn off the computer (not the UPS!) | ||
{{:cell_observer_pc_vs_ups.png?250|}} | {{:cell_observer_pc_vs_ups.png?250|}} | ||
- | * If you used any __immersion oil in the objectives, clean them up__. | + | * Clean up immersion objectives |
- | * Turn off the microscope power supply (B) | + | * Turn off the microscope power supply (**B** on remote control) |
* Turn off the Definite Focus controller (if used) | * Turn off the Definite Focus controller (if used) | ||
- | * Turn off the Motorized Stage controller (A) | + | * Turn off the motorized stage controller (**A** on remote control) |
* Turn off the Temperature and CO2 controller (if used) | * Turn off the Temperature and CO2 controller (if used) | ||
- | * If there's __another user__ for this microscope in the __next hour__ leave the mercury __lamp power source on, else turn it off__. | + | * Turn off the HXP 120 fluorescent light source |
- | * Be extra careful in weekends and at the end of the day to make sure that the mercury lamp is not going to be turned on for an excessive time. | + | |
---- | ---- | ||
[[resources|Back to the Resources page]] | [[resources|Back to the Resources page]] |