This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
zeiss_axiovert_200m [2020/01/01 22:13] bioimaging |
zeiss_axiovert_200m [2020/01/14 17:46] bioimaging [Microscope Turn Off procedures] |
||
---|---|---|---|
Line 92: | Line 92: | ||
===== System Turn On Procedures ===== | ===== System Turn On Procedures ===== | ||
- | * Turn the fluorescence light power source on. | + | * Turn on the fluorescent light power source |
{{halide_710.jpg?80|}} | {{halide_710.jpg?80|}} | ||
- | * Turn the Prior microscope stage controller on. | + | * Turn on the Prior stage controller |
{{ax_prior_on.jpg?100|}} | {{ax_prior_on.jpg?100|}} | ||
- | * Wait 10s then turn the microscope on. | + | * Turn on the microscope |
{{ax_mic_on.jpg?100|}} | {{ax_mic_on.jpg?100|}} | ||
- | * Turn the camera on. | + | * Turn on the CCD camera |
{{ax_cam_on.jpg?100|}} | {{ax_cam_on.jpg?100|}} | ||
- | * Turn the computer on. | + | * Turn on the computer |
- | * Login to the computer (Bioimaging User). | + | * Log in to Windows (Bioimaging User) |
- | * Start the Metamorph software. | + | * Start the Metamorph software |
+ | * If the software doesn't detect the camera, power cycle the camera and try again | ||
===== Microscope Turn Off procedures ===== | ===== Microscope Turn Off procedures ===== | ||
- | * Turn off the computer. | + | |
- | * Turn off the camera. | + | If there is another user for this microscope in the __next hour__: |
- | * If you used any __immersion oil in the objectives, clean them up__. | + | * Leave the fluorescent lamp on |
- | * Turn off the microscope stage controller. | + | * Clean up immersion objectives |
- | * Turn off the microscope. | + | Else: |
- | * If there's __another user__ for this microscope in the __next hour__ leave the mercury __lamp power source on, else turn it off__. | + | * Clean up immersion objectives |
- | * Be extra careful in weekends and at the end of the day to make sure that the mercury lamp is not going to be turned on for an excessive time. | + | * Shutdown the computer |
+ | * Turn off the camera | ||
+ | * Turn off the Prior stage controller | ||
+ | * Turn off the microscope | ||
+ | * Turn off the fluorescent lamp | ||
---- | ---- | ||
[[resources|Back to the Resources page]] | [[resources|Back to the Resources page]] |